installation of this accessory should follow approved guidelines to ensure quality installation.
Preparation
Remove negative battery cable
Installation
1. From front of vehicle, run the DRL’s wire
harness on the driver side from the battery
towards the firewall of the car. Use wire ties
as needed (picture 1 & 2)
Picture 1
Picture 2
2. Locate the large vehicle harness grommet
on the left side. If accessible, cut the
auxiliary wiring access nipple off the
grommet or cut ¼” slit in grommet and push
the red, black, black-white and red-white
wires through firewall. Note: Extra caution
should be taken not to damage the pin
connectors. Seal with 3M Silicone sealant
(picture 3)
Picture 3
Vehicle Disassembly
3. Remove driver side door scuff plate.
Disengage with panel tool and remove
(picture 3)
Picture 3
4. Remove the driver side cowl side trim
(picture 6). Unscrew the cowl side trim clip.
Comments to this Manuals