Scion 2008 xB Installation Manual download pdf (Page 40)

2008 SCION xB MAF TUBE INSTALLATION

Procedure

Issue A: 04/28/08 Page 40 of 48

(f) Install the factory MAF sensor onto the TRD

MAF tube, with the provided 4mm screws. (Fig.

19-4)

Make sure the MAF sensor O-ring is not

pinched and is fully seated inside the MAF

sensor mount on the tube.

(g) Install the aluminum MAF tube between the

rubber inlet tube and the s/c inlet elbow. Secure

using the supplied rubber isolator spacer, 6mm

hardware and the provided hose clamps. USE

HAND TOOLS ONLY. (Fig. 19-5)

(

h) Split the factory MAF harness to gain the

necessary length for the MAF plug to reach the

relocated MAF element. Wrap wire section

with electrical tape.

(i) Reconnect the MAF sensor connector. Torque

to 80 in-lbs. (Fig. 19-5)

2.5mm Allen

wrench

Fig. 19-4

Fig. 19-5

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments