Scion 2007 tC User Manual download pdf (Page 18)

SCION tC 2007 SUPERCHARGER

Procedure

Page 18 of 36

Issue A: 04/10/07

8. Crankshaft Pulley Bolt.

(a) Remove Passenger Side Front Wheel in order

to properly access fender shroud and

crankshaft pulley bolt.

(b)

Remove passenger side plastic body/fender

shrouds in order to gain access to crankshaft

pulley. Fig. 51 and Fig. 52.

(c)

Remove factory crankshaft pulley bolt. Utilize

SST 09213-54015-01 and 09330-00021. Fig.

53. CAUTION: be careful not to damage OE

power steering hard line when working with

crankshaft pulley. See arrow in Fig. 54.

(d)

DO NOT remove pulley from crankshaft!

Remove ONLY the retaining bolt. NOTE:

some crankcase oil may drip out. This is

normal.

(e)

Clean and coat the threads of the TRD Hi-

Strength 12-Point Bolt with

Red Loctite 272

Thread Locking Compound or equivalent.

Install into crankshaft pulley. Using the SSTs

and a 1/2 inch drive TORQUE WRENCH,

Torque to 150 ft-lbs.

(f)

Leave passenger side plastic body/fender

shroud and fasteners off until the very end of

the installation. This will make it much easier

to install the TRD supplied serpentine belt later

on. Leave passenger side front wheel assembly

off as well, until the end of the installation.

Fi

g

. 53

Fi

g

. 51

Fi

g

. 52

Fi

g

. 54

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comments to this Manuals

No comments