Scion 2007 tC User Manual download pdf (Page 25)

SCION tC 2007 SUPERCHARGER

Procedure

Page 25 of 36

Issue A: 04/10/07

10. Oil Feed Line & Air Conditioner Hose.

(a) Next, attach TRD supercharger Oil Feed Line

to TRD hexagonal T fitting. Connect the 90

degree bend end of the oil feed line to the T

fitting. Leave hand tight for now. Fig. 77.

(b)

Attach the other, straight end, of Oil Feed Line

to supercharger fitting. Leave hand tight for

now. See Fig 77.

Do not use Teflon paste on

AN fittings. The feed tube should route

between heater hoses. Heater hose clamp will

need to be relocated about 8 inches rearward.

(c)

Adjust plastic water line clamp as needed to

reposition water lines so that they do not

interfere with Oil Feed Line.

(d)

Now carefully tighten both ends of the Oil

Feed Line (9/16” wrench) and recheck for

clearance around line. Loosen and re-clock as

needed until line is clear and then re-tighten

into place. Fig. 78.

Do not over-tighten AN

fittings!

(e)

Install the two different AC-hose relocation

brackets. You will utilize one TRD-supplied 6

x 1.0 x 12 mm flange head bolt for each

bracket,

in addition to the OE fasteners.

(f)

Reconnect Alternator, Crank Position Sensor,

and AC Pump wires.

(g)

Add wire clamp to A/C line at the supercharger

front bearing bracket. Reuse OE 6mm bolt

removed from alternator in previous step to

fasten clamp to cast aluminum SC bracket.

Use 2 small TRD-provided zip ties to secure

CPS wire to wire loom. Keep wires and wire

connectors strain-free and away from the

exhaust manifold heat and drive pulley as

much as possible. See Fig. 83

Fi

g

. 82

10mm

wrench

9/16”

9/16”

Fi

g

. 78

Fi

g

. 77

Fi

g

. 83

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comments to this Manuals

No comments