Scion 2007 tC User Manual download pdf (Page 30)

SCION tC 2007 SUPERCHARGER

Procedure

Page 30 of 36

Issue A: 04/10/07

(m) Fit TRD inlet manifold to supercharger.

NOTE: Use a small amount of motor oil or

equivalent to lubricate the intake bore and O-

ring surface interface prior to assembly. Be

sure to align manifold so that all hoses are free

from kinks and away from any sharp edges.

Using the cast-in locator arrow, align arrow

approximately with top fastener hole. See Fig

103.

Torque to 15 inch-lbs.

(n) Utilizing the 3 TRD supplied 6 x 1.0 x 16mm

SHCS and three 6 mm flat washers, clamp

down TRD inlet manifold to supercharger

assembly. 5 mm Allen wrench. See Fig. 103.

(o)

Tighten all hose clamps for bypass hose and

inlet manifold hose.

(p)

Install valve cover breather hose onto valve

cover. Fig. 104.

Be sure hose is not kinked. Re-adjust as necessary.

(q)

Install the TRD flexible rubber fender inlet

piece onto lower air box assembly.

(r)

Install the low-profile TRD supplied spacers

and grommets into the TRD supplied lower

airbox. Now install airbox assembly into

place, making sure that the flexible rubber inlet

fits correctly into fender hole without

obstruction (See Fig 105). Using the 3 OE

fasteners, secure into place.

Torque to 44

inch-lbs.

See Fig. 106. Remove mass airflow

sensor from O.E. upper airbox and install into

TRD upper airbox using O.E. screws.

Fi

g

. 103

Fi

g

. 106

Fi

g

. 105

Fi

g

. 104

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments